Schiit Saga S

Thương hiệu

Giá đang cập nhật

Bảo hành

Bảo hành 12 tháng

Nguồn điện: 230VAC

Thông tin chi tiết

Saga S is just like Saga+—without the tube. Like Saga+, Saga S gives you all the uber-high-end, no-compromises features you need in a preamp, including a real relay-switched volume control, a switchable DC-coupled discrete JFET buffer, and a custom remote control.

Saga S: The Solid-State Saga
What is Saga S? It’s simple—it’s basically a Saga+ with a discrete JFET buffer stage in place of the tube stage. We understand some people don’t want to deal with tubes, so we went ahead and made one that was 100% solid state.

It’s Your Choice: Passive or Active
Go ahead. Run Saga S in passive mode for a convenient remote-controlled passive preamp that’s ideal for many systems. If you need to drive long cables, switch it to the discrete, DC-coupled JFET buffer mode.
Easiest Relay-Switched Volume, Ever
The benefits of a relay-switched stepped attenuator for volume are clear. Compared to a potentiometer, they give you essentially perfect channel matching and near-unmeasurable distortion. However, some preamps with relay-stepped attenuators confuse you with buttons and screens. Not Saga S. Saga S has a volume knob that works just like a volume knob—just grab and turn. And if you use the remote control, the motorized potentiometer changes to match the remote setting.
Perfect Companion to Our DACs
Want a remote-controlled system to interface your digital gear with the rest of your system? Stack Saga S and Bifrost (or any other of our DACs) for a true no-compromise remote-controlled system.
Xem thêm

Thông số kỹ thuật

Buffer Stage:

Frequency Response: 20Hz-20Khz, -0.2db, 3Hz-400KHz, -3dB
THD: <0.001%, 20Hz-20KHz, at 1V RMS
IMD: <0.001%, CCIR (active stage)
SNR: >110db, A-weighted, referenced to 1V RMS
Output Impedance: 75 ohms
Maximum Output: >5V RMS

Passive Stage:

Output Impedance: varies, maximum 4.8 kohms

Both Passive or Active Stage:

Gain: Approximately 1 (0dB) through either passive or active stage
Input Impedance: 10 kohms
Crosstalk: >-75dB, 20Hz-20KHz

5 RCA pairs, selectable via front switch or remote
Outputs: 2 RCA pairs, selectable via front switch or remote
Buffer Stage: Discrete two-JFET buffer with DC offset correction
Volume Control: relay-switched stepped attenuator with discrete thin-film resistors , 64 1dB steps
Power Supply: One 24VA transformer with regulated +/-18V rails, plus 5VDC for microprocessor
Power Consumption: 15W typical

Size: 9″W x6″D x 2″H, plus additional 1.25″ H for tube
Weight: 6 lbs